WOULDN'T YOU LIKE TO TAKE ME HOME? HERE'S WHY YOU WANT A TENT IN YOUR BED A QUESTION FOR LITTLE OLD ME? WOULD YOU LIKE TO SEE MY PARTS? THIS IS HOW BIG I GET LET'S PUT SOME PARTS TOGETHER I PROMISE I WON'T TELL ANYBODY WOULD YOU LIKE TO SEND ME AN E-MAIL? YOU CAN TELL YOUR FRIENDS ABOUT US

HERE ARE ALL THE PARTS YOU SHOULD HAVE                  CREATOR OF THE WORLD FAMOUS SLEEPTYIME TOE-TENT 

This page is the Parts List (i.e. what you should have in the box).

 

1) Set of Printed Instructions.

1) Plastic "Joiner".

 THIS IS EXTRUDED PLASTIC, 1/10 INCH NOMINAL THICKNESS

 

2) Aluminum "Lower Supports".

THESE ARE POWDER-COATED SHEETS OF 5052 ALUMINUM, 1/10 INCH THICK

 

2) Plastic "Hubs".

THESE ARE INJECTION MOLDED PLASTIC PARTS

 

2) Aluminum "Upright Supports".

THESE ARE POWDER-COATED BARS OF 6061 ALUMINUM, 1/2 INCH DIAMETER

 

1) Aluminum Rod, 30 inches long, threaded on one end.

THIS IS AN ANODIZED ROD OF 6061 ALUMINUM, 3/8 INCH DIAMETER

 

2) Aluminum Tubes, 36 inches and 20.8 inches, each with one threaded stud end.

THESE ARE POWDER-COATED TUBES OF 6061 ALUMINUM, 3/8 INCH INNER DIAMETER, 1/2 INCH OUTER DIAMETER

 

1) Plastic Tube, 19.8 inches long.

THIS IS CLEAR PLASTIC PVC TUBING

 

5) Plastic "Joiner Pins" (Four required and one spare).

THESE PLASTIC PINS WILL FIT INTO EACH OTHER

 

2) Plastic Sheet Clips (Optional, sent only if requested). See section 11 of the Assembly Instructions Page for further information on these clips.

THESE CLIP ONTO THE OUTER COIL OF YOUR MATTRESS TO HOLD A FITTED TOP SHEET

 

WOULDN'T YOU LIKE TO TAKE ME HOME? HERE'S WHY YOU WANT A TENT IN YOUR BED A QUESTION FOR LITTLE OLD ME? WOULD YOU LIKE TO SEE MY PARTS? THIS IS HOW BIG I GET LET'S PUT SOME PARTS TOGETHER I PROMISE I WON'T TELL ANYBODY WOULD YOU LIKE TO SEND ME AN E-MAIL? YOU CAN TELL YOUR FRIENDS ABOUT US

 

SleepyTime Manufacturing, Seattle, WA.  (206) 349-5135  This page was last updated on: 04/10/2008 12:48 AM